Panasonic PX380G-BS300, Operating Instructions Manual

Page: 73 / 229

– 73 –
Chapter 4 Shooting — Adjusting image quality
r Advanced settings
Configure the settings in the main menu → [SCENE FILE] → [KNEE SETTING].
f When the <OUTPUT>/<AUTO KNEE> selector switch is set to <ON>, and [ON] is selected in the main menu → [SW MODE] → [AUTO KNEE SW]
[A.KNEE RESPONSE]: Sets the speed of response. Smaller values make the response faster.
f When the <OUTPUT>/<AUTO KNEE> selector switch is set to <OFF>, and [ON] is selected in the main menu → [SCENE FILE] → [KNEE SETTING]
→ [MANUAL KNEE]
[KNEE MASTER POINT]: Sets the knee point position in 0.5% steps.
[KNEE MASTER SLOPE]: Sets the knee inclination.
[KNEE MASTER SLOPE Rch]: Sets the knee inclination of Rch.
[KNEE MASTER SLOPE Bch]: Sets the knee inclination of Bch.
High color function
This function sets the color dynamic range.
r General settings
[HI-COLOR SW]: Turns the mode that expands the color dynamic range [ON]/[OFF].
[HI-COLOR LVL]: Selects the level of mode that expands the color dynamic range.
r Advanced settings
Use the camera in a general settings.
White clip function
This function sets the brightest part of video signals to be not brighter than a certain level.
r General settings
Use the camera with the factory settings.
r Advanced settings
Configure the settings in the main menu → [SCENE FILE] → [WHITE CLIP SETTING].
[WHITE CLIP]: Turns the white clip function [ON]/[OFF]. When the function is [ON], the setting value of [WHITE CLIP LVL] is enabled.
[WHITE CLIP LVL]: Sets the white clip level.
[Rch CLIP LVL]: Sets the clip level of Rch for white clips.
[Bch CLIP LVL]: Sets the clip level of Bch for white clips.
Acquiring position information from external device
This camera can acquire the position information (latitude, longitude, and altitude) from the bonding device connected via network.
Set the main menu
→ [OTHER FUNCTIONS] → [GPS] to [EXTERNAL].
The acquired position information is recorded in the clip as clip metadata.
The position information can be confirmed in the main menu
→ [NETWORK SETUP] → [NETWORK TOOLS] → [STATUS DISPLAY].
@ @
NOTE
t The position information may not be acquired depending on the connected bonding device.
t For details on bonding device that can acquire the position information, visit the support desk at the following website:
https://pro-av.panasonic.net/