Panasonic PV-500, User Manual, Page: 412 / 494

410
C
o
nt
rol
w
it
h C
om
m
uni
c
a
tion P
or
t
C
h
ap
te
r 9
Read Out Command
This is a command that reads out the settings of PV500 and inspection results. For the information of readable
data, refer to the pages after page 380.
When reading one of data (such as Execution time,
Total judgement, Maximum value, or Minimum value)
Send % P R Parameter BCC CR
Receive
% P R $ Parameter = Data BCC CR
Error (ERROR 1 signal = ON)
% P R ! Error code (3-digit) BCC CR
Example: Reads out Execution time 1.
Send
% P R S Y S _ T I M E 1 BCC CR
Receive
% P R $ S Y S _ T I M E 1 = 5 3 . 2 5 BCC CR
When reading two of data (such as Maximum value and
Minimum value)
Send
% P R P Parameter BCC CR
Receive % P R P $ Parameter = Data 1 , Data 2 BCC CR
Error (ERROR 1 signal = ON)
% P R P ! Error code (3-digit) BCC CR
Example: Reads out the maximum and minimum values of slice level group "A".
Send
% P R P B L V : P A I R A BCC CR
Receive
% P R P $ B L V : P A I R A = 8 0 , 2 5 5 BCC CR
Minimum Maximum
Error codes for Read Out command
200
Operation is stopped.
251 Specification of the parameter is wrong. (Undefined parameter is specified.)
252 The specified parameter does not exist. (e.g. You tried to read out the setting value of an
uncreated checker.)