Panasonic PV-500, User Manual

Page: 272 / 494

270
Se
tt
ing I
n
s
p
e
c
tio
n C
on
d
it
ions
C
h
ap
te
r 4
4.15 Outputting Inspection Results to the External Device
PV500 has features of outputting judgements of inspections and results of numerical calculations through the
parallel I/O connector, the I/O terminal block, and the ports, and writing them in an attached SD memory card.
In addition, captured images can be saved in a PC through Ethernet port and written in an attached SD memory
card.
Multiple data can be output to multiple destinations. For example, a judgement is output to the I/O connector, a
result of numerical calculation is output to a PLC through the COM.0 port, and an inspection image is output to
a PC through Ethernet port at the same time.
These settings are set in “Input/Output” setting window.
Displaying the Input/Output Setting Window
1.
Select "ENVIRONMENT" from the menu bar.
2.
Select "Input/Output".
“Input/Output” setting window is displayed.
4.15.1 Outputting through Parallel I/O
Scan count, Judgement, or result of numerical calculations can be output to the parallel I/O connector and
Judgement No.0-7 can be output to the parallel I/O terminal block.
Outputting a Result of Judgement Expression
•
Judgement that can be output is JDC (External output register). JRC (Internal register) cannot be
output.
•
When outputting a Judgement result while you inspect in "Automatic Switch" mode, PV outputs the
result of only the block executed lastly.
Outputting Judgement No.0-15 (No.0-7)
When execution mode is “Execute All”, Judgements No.0-15 are output to the “OUT0-15” of the I/O connector
and Judgements No.0-7 are output to the “OUT0-7” of the I/O terminal block.
When execution mode is “User-Defined” or “Automatic Switch”, 16 points are output to the “OUT0-15” of the I/O
connector and 8 points are output to the “OUT0-7” of the I/O terminal block in ascending order from the
smallest number of judgement of the executed block or the last executed block respectively.
1.
Select “Parallel I/O Output” in
“Input/Output” setting window.
2.
Select “Once, Judgement(16 bit)” for
“Output Data”.