Image adjust
ENGLISH -
47
Settings
Sharpness
Press ▲▼ to select [Sharpness].
1 )
Press the <ENTER> button to display
2 )
the adjustment dialog box.
Press ◄► to adjust the setting value.
3 )
Operation
Adjustment
Adjustment
range
Press ►.
increase the
sharpness of the
image
Maximum
value 15
Press ◄.
decrease the
sharpness of the
image
Minimum
value 0
Note
When [Daylight View] is set to [On] or [Auto], the
z
[Sharpness] is disabled.
Gamma
Press ▲▼ to select [Gamma].
1 )
Press the <ENTER> button to display
2 )
the adjustment dialog box.
Press ◄► to adjust the gamma value
3 )
to obtain a better balance of contrast.
Adjustments can be made between
z
0 and 15.
Noise reduction
Reduces noise when viewing old video or other
images affected by noise.
Press ▲▼ to select [Noise reduction].
1 )
Press the <ENTER> button to display
2 )
the adjustment dialog box.
Press ◄► to select the desired item.
3 )
Off
Disabled
L 1
Lower reduction
L 2
Higher reduction
Note
When input video signal to the projector, [Noise
z
reduction] will become available.
When you select [480p], [576p], [720p], [1035i] , [1080i],
z
[D-480p], [D-576p], [D-720p], [D-1035i], [D-1080i], or
[D-1080p] is selected in System Menu under component
input signal (
Æ
page 40) , [Noise reduction] is disabled
and cannot be displayed.
Progressive
An interlaced video signal can be displayed in
progressive mode.
Press ▲▼ to select [Progressive].
1 )
Press the <ENTER> button to display
2 )
the dialog box.
Press ◄► to select the desired item.
3 )
Off
Disabled
L 1
For an active picture
L 2
For a still picture
Film
For watching a film
Note
When input video signal to the projector, [Progressive]
z
will become available.
When you select [480p], [576p], [720p], [1035i] , [1080i],
z
[D-480p], [D-576p], [D-720p], [D-1035i], [D-1080i], or
[D-1080p] is selected in System Menu under component
input signal (
Æ
page 40) , [Progressive] is disabled and
cannot be displayed.
Reset
To reset the adjusted data, all adjustments will return
to their previous figures.
Press ▲▼ to select [Reset].
1 )
Press the <ENTER> button.
2 )
A confirmation box appears and then select [Yes].
z
Note
To reset the adjusted data except [
z
Daylight View].
Store
Press ▲▼ to select [Store].
1 )
Press ► or the <ENTER> button.
2 )
Press ▲▼ to select one from Image 1
3 )
to 4 and press the <ENTER> button.
A confirmation box appears and then select [Yes].
z
Note
To store the adjusted data except [
z
Daylight View
].
Make sure you selected [Store] after adjusting
z
settings. Some settings can not be stored if not
registered with [Store] function.