Setting
ENGLISH -
55
Settings
Subpicture size
J
Press ▲▼ to select [Subpicture size]
1 )
and then press the <SELECT> button.
Press ▲▼ to select one among the
2 )
items as below.
You can change the subpicture size among
z
Small, Middle and Large.
Subpicture position
J
Press ▲▼ to select [Subpicture
1 )
position] and then press the <SELECT>
button.
Press ▲▼ to select one among the
2 )
positions as below.
You can adjust the subpicture position. (the
z
bottom right, the top right, the top left and the
bottom left).
Attention
Subpicture size and Subpicture position works only under
z
P IN P mode.
The Picture in Picture function is not available depending
z
on the input signals and the selected input terminals.
When the input signal(s) is/are incompatible, mark will
z
be displayed on the Main/Sub picture.
Power management
For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not operated for a certain period.
Press ▲▼ to select [Power
1 )
management].
Press ► or the <SELECT> button to
2 )
access the submenu.
Mode
J
Press ▲▼ and then press the
1 )
<SELECT> button to select one mode
among the items as below.
Ready
When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition,
the projection lamp will be turned on
if the input signal is reconnected or
any button on the control panel or
remote control is pressed
Shut
down
When the lamp has been fully cooled
down, the power will be turned off.
Off
Power management function is off.
Timer
J
Press ▲▼ to select [Timer] and then
1 )
press the <SELECT> button.
Press ▲▼ to set the Timer(1~30min).
2 )
Direct on
Press ▲▼ to select [Direct on] and
1 )
then press the <SELECT> button.
Press ▲▼ to switch between On and
2 )
Off.
When this function is set to On, the projector
z
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
z
projector is turned off in the incorrect sequence,
the Direct On function does not work properly.
Standby mode
This function can set the electric power when the
projector is standing by.
Press ▲▼ to select [Standby mode]
1 )
and then press the <SELECT> button.
Press ▲▼ to switch between the items
2 )
as below.
Eco
Restricts some functions in
standby mode to reduce power
consumption.
Network
Does not restrict functionality
even in standby mode
Note
When selecting Network, the cooling fans may be running
z
depending on the temperature inside the projector even if
the projector is turned off.
Refer to "Operating Instructions - Network Operations
z
".
If Standby mode is set to [Eco], you cannot use network
z
functions when the projector is standing by. Also, you
cannot use some RS-232C protocol commands.
If set to [Network], you can use network functions when
z
the projector is standing by.
P-Timer
This function allows you to change the setting of the
P-timer and execute it.
Press ▲▼ to select [P-Timer].
1 )
X
