Setting
54
- ENGLISH
Settings
PIN code change
J
The PIN code can be changed to your desired four-
digit number.
Press ▲▼ to select [PIN code change]
1 )
and then Press <ENTER> button.
Current Pin code dialog box appears.
z
Press ▲▼ to enter the current code.
2 )
Press ► button to fix the number and
move the red frame pointer to the next
box.
The New PIN code input dialog box appears.
z
Repeat these steps to set a new PIN
3 )
code.
Fan
Press ▲▼ to select [Fan] and then
1 )
Press <ENTER> button.
Press ▲▼ to select one option .
2 )
This function provides the following options in
z
the cooling fans’ operation when the projector is
turned off.
L 1
Normal operation.
L 2
The fan speed is the same as
L1, but it takes more time to cool
the projector down.
Fan control
Press ▲▼ to select [Fan control] and
1 )
then Press <ENTER > button.
Press ▲▼ to select one among
2 )
options as below.
Choose the running speed of cooling fans from
z
the following options according to the ground
elevation under which you use the projector.
Off
Normal speed.*
1
On 1
Faster than Off mode.*
2
On 2
Faster than On 1 mode.*
3
Set this function to [Off] when using the projector
*1 :
in non-high altitude environment.
Select this mode when using the projector in high
*2 :
altitudes (about 1,200 meters or more above
the sea level) where the fans have less cooling
effect.
Select this mode when using the projector in
*3 :
higher altitudes ( than above where the fans
have less cooling effect).
Note
Failure to set the running speed of cooling fans
z
properly may affect the projector life.
The fan noise becomes louder in [On 1] and [On 2].
z
Video delay control
This function allows you to make a digital processing
of a projected image faster.
Press ▲▼ to select [Video delay
1 )
control] and then Press the <ENTER>
button.
Press ▲▼ to select one item between
2 )
On and Off.
Note
[Noise reduction] and [Progressive] can not be
z
selected when [Video delay control] function is set
to [On].
Lamp runtime
This function is used to display the cumulative lamp
operating time and reset the lamp runtime.
Press ▲▼ to select [Lamp runtime] and
then press ► or the <ENTER> button to
show submenus.
Lamp runtime
J
Show the total accumulated lamp run time.
Lamp runtime reset
J
After replacing the lamp unit, be sure to reset the
timer.
Press the <ENTER> button to reset.
[Lamp runtime Reset?] appears. Select [Yes] to continue.
z
Another confirmation dialog box appears, select [Yes] to
reset the Lamp runtime.
Attention
When the lamp run time is elapsed the estimated
z
duration, the Lamp replacement icon (
Æ
page 60) will
appear on the screen, indicating that the end of lamp life
is reached. When replacing the lamp unit, reset the lamp
runtime.
