Panasonic PT-RQ32KU, Operating Instructions Manual

Page: 218 / 285

Chapter 6 Maintenance — Light source/temperature/filter indicators
218 - ENGLISH
Light source/temperature/filter indicators
When an indicator lights up
If a problem occurs inside the projector, the light source indicators <LIGHT1>/<LIGHT2>, temperature indicator
<TEMP>, or filter indicator <FILTER> will inform you by lighting or blinking in red. Check the status of the
indicators and take following measures.
Attention
f
When switching off the projector to deal with problems, make sure to follow the procedure in “Switching off the projector” (
x
page 71).
Light source indicator <LIGHT1>
Light source indicator <LIGHT2>
Temperature indicator <TEMP>
Filter indicator <FILTER>
Light source indicators <LIGHT1>/<LIGHT2>
Indicator status Status Solution
Lighting in red
f
Some of the elements of the light
source are defective and the light
output has decreased.
f
Turn the <MAIN POWER> switch to <OFF> (
x
page 71), and turn on the
power again.
Blinking in red
(1 time)
f
The light source is turned off since
the projection lens cannot be
detected.
f
Turn off the power and mount the projection lens again. (
x
page 49)
f
Turn the <MAIN POWER> switch to <OFF> (
x
page 71), and turn on the
power again.
Blinking in red
(2 times)
f
The light source does not light up,
or the light source turns off while the
projector is in use.
f
Turn the <MAIN POWER> switch to <OFF> (
x
page 71), and turn on the
power again.
Blinking in red
(3 times)
Note
f
If the light source indicators <LIGHT1>/<LIGHT2> are still lit or blinking after taking the measures, set the <MAIN POWER> switch to
<OFF>, and ask your dealer for repairs.
f
The light source indicator corresponding to the light source being lit will light up in green if the projector is in projection mode and there is no
indication of problem by lighting or blinking in red.