![Panasonic PT-RQ32KU Operating Instructions Manual Download Page 177](http://html1.mh-extra.com/html/panasonic/pt-rq32ku/pt-rq32ku_operating-instructions-manual_4718480177.webp)
Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 177
4) When the confirmation screen is displayed, press
qw
to select [OK], and press the <ENTER> button.
f
The [PROJECTOR SETUP] menu
→
[STATUS]
→
[FILTER COUNTER] is displayed as “0”.
Note
f
If the recommended time to replace the filter is set, the filter runtime (counter numerical value) and the recommended time to replace the
filter are displayed in [FILTER COUNTER RESET].
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1) Press
as
to select [SAVE ALL USER DATA].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
4) When the confirmation screen is displayed, press
qw
to select [OK], and press the <ENTER> button.
f
[PROGRESS] is displayed while saving data.
Note
f
Data set from the computer application is not included in [ALL USER DATA].
f
The data saved by executing [SAVE ALL USER DATA] is not deleted even if the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[ALL
USER DATA] is executed.
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1) Press
as
to select [LOAD ALL USER DATA].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
4) When the confirmation screen is displayed, press
qw
to select [OK], and press the <ENTER> button.
Note
f
The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f
Data registered from a computer is not included in [ALL USER DATA].
[INITIALIZE]
Return various setting values to their factory default settings.
1) Press
as
to select [INITIALIZE].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The
[INITIALIZE]
screen is displayed.
4) Press
as
to select an item to initialize.
[ALL USER DATA]
Returns all setting values including [REGISTERED SIGNAL], [NETWORK/E-MAIL], and [LOGO
IMAGE] to the factory default settings.
The projector enters the standby mode to reflect the setting values.
[REGISTERED SIGNAL]
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in “Deleting the
[NETWORK/E-MAIL]
Returns [NETWORK SETUP] and [E-mail set up] to factory default settings.
[LOGO IMAGE]
Deletes the image registered in [USER LOGO].
5) Press the <ENTER> button.