Panasonic PT-REZ12, Operating Instructions Manual

Page: 211 / 313

Chapter 4 Settings — [NETWORK] menu
ENGLISH - 211
Note
f
When [COMMAND PROTECT] is set to [DISABLE], the projector becomes vulnerable against a threat on the network because connection
authentication will not be performed. Use this function by understanding the risk.
f
When a password is not set for the administrator account (when blank), [COMMAND PROTECT] cannot be set.
f
For details on how to use the command control function, refer to “Control commands via LAN” (
x
page 280).
[NETWORK CONTROL]
Set the controls of the projector via the network.
f
To use the network function with the projector, it is necessary to set the password of the administrator account.
(
x
page 209)
1) Press
as
to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f
The [NETWORK CONTROL] screen is displayed.
3) Press
as
to select an item, and press
qw
to change the setting.
[WEB CONTROL] Set to [ON] to control with the web browser.
[COMMAND CONTROL]
Set to [ON] to control with the <SERIAL IN> / <SERIAL OUT> terminal control command format
(
x
page 287). Refer to “Control commands via LAN” (
x
page 280).
[COMMAND PORT] Set the port number used for command control.
[Crestron Connected
TM
]
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
[AMX D.D.]
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, visit the
following website of AMX Corporation.
https://www.amx.com/
4) Press
as
to select [STORE], and press the <ENTER> button.
f
The confirmation screen is displayed.
5) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
When a password is not set for the administrator account (when blank), the network function of the projector cannot be used. When using
the web control function or the communication control via LAN (including operation by application software), set a password.
f
[Crestron Connected
TM
] cannot be set when the [NETWORK] menu
→
[WIRED LAN]
→
[IP VERSION] is set to [IPv6].
[PJLink]
Set the PJLink function which controls and monitors the projector using the PJLink protocol.
f
To use the PJLink function with the projector, it is necessary to set the password of the administrator account.
(
x
page 209)
Note
f
When a password is not set for the administrator account (when blank), the network function of the projector cannot be used. When using
the web control function or the communication control via LAN (including operation by application software), set a password.
[PJLink PASSWORD]
Set the security authentication password required to connect to the projector.
1) Press
as
to select [PJLink].
2) Press the <ENTER> button.
f
The [PJLink] screen is displayed.
3) Press
as
to select [PJLink PASSWORD], and press the <ENTER> button.
f
The [PJLink PASSWORD] screen is displayed.
4) Press
as
to select [PASSWORD] in [CURRENT], and press the <ENTER> button.
f
The [PASSWORD] screen is displayed.
5) Press
asqw
to select the text, and press the <ENTER> button to enter the text.
f
Enter the current PJLink password.
f
The factory default setting of password is blank.