Using Remote control
20
- ENGLISH
Preparation
Installing and Removing battery
Press the guide and pull
1
)
out the battery base.
3
VO
LT
S
CR202
5
M
3
V O
LT
S
CR2025
Install new battery into
2
)
the compartment.
3
VO
LT
S
CR202
5
M
3
V O
LT
S
CR2025
Remove the old
Lithium coin cell
battery and install
new one (CR2025).
Ensure that the side
with a “+” is facing
up.
Put the battery base
3
)
back.
3
VO
LT
S
CR202
5
M
3
V O
LT
S
CR2025
Attention
When discarding a lithium coin battery, be sure both sides (+/-) are covered with adhesive insulating tape, such as and the
z
cellophane tape, and discard it according to the instructions of the local government.
Setting Remote control
ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the remote control ID of the projector, set the same remote control ID to the remote control.
There are 7 different remote control IDs: [All], [ID1]~[ID6], the initial remote control ID is [All].
Setting the remote control ID
J
1) While holding down the <MENU> key, press the <IMAGE> key. The number of times you press the
<IMAGE> key corresponds to the desired remote control ID.
The number of times to press the <IMAGE> key is as follows:
ID1 = Once, ID2 = Twice, ID3 = 3 times, ID4 = 4 times, ID5 = 5 times, ID6 = 6 times.
2) The remote control ID is changed when the <MENU> button is released.
J
Resetting the remote control ID
The remote control ID is reset to [All] (default) by pressing the <MENU> key and <IMAGE> key at the
same time for 10 seconds or more.
Note
When operating the projector under [All] code, you can operate several projectors at the same time.
z
If the <IMAGE> button is pressed 7 times or more, the remote control ID cannot be changed (the operation is invalid).
z
For setting the remote control ID codes, see [Remote ID] in the [Setting] menu. (
z
Æ
page 41)
If the battery is not in use for a long period of time and is removed from the remote control, the remote control ID will be
z
reset.
Using Remote control
