E
NGLISH - 34
Settings
OPTION menu
When you change the input method, the guidance
appears in the upper right corner of the screen. The
following display methods are available. Press
I
H
to
cycle through the options.
You can switch the logo on/off that is displayed when
starting up the projector. Press
I
H
to select the
required option.
STARTUP LOGO
will be displayed for
30 seconds.
ON
Active
OFF
Deactive
USER
Display the original text
Q
Editing the original text
If you select
USER
, you can display the 2 lines of
original text up to 40 characters in 1 line instead of
the logo.
1. Select
USER
and press
ENTER
.
2. Select the required line to enter or edit the original
text, and press
ENTER
.
3. Use
F
G
I
H
to specify the location of the
required character and press
ENTER
.
The selected character will be displayed in the box.
Select
DELETE
to delete the last entered character
and press
ENTER
.
4. Repeat the step 3 until you finish the text to display
in a line.
5. Select
OK
and press
ENTER
to set the entered
text in a box.
Press
G
and edit the
TEXT2
if you need to, and
repeat the step 3 - 5.
You can switch the function of the
COMPUTER2 IN/
1 OUT
terminal.
INPUT
COMPUTER2 IN
OUTPUT
COMPUTER1 OUT
You can check the remaining amount of the
ARF
(Auto
Rolling Filter). The color of the bar scale is indicating the
condition of the
ARF
.
Yellow
The filter remaining amount is getting
low.
Red
No more remaining.
You can check how long the lamp has been used.
INPUT GUIDE
Options
Function
OFF
Turn off the guidance.
SIMPLE
Display the input method by text.
The
INPUT GUIDE
will go out after
5 seconds without any operation.
DETAILED
Display the input method by graphic.
The
INPUT GUIDE
will go out after
10 seconds without any operation.
If you select any
COMPUTER
terminal which has no signal, the
computer connection guidance will
be displayed. See “Computer
connection guidance” on page 46.
STARTUP LOGO
Remote control
Control panel
See “Navigating through the MENU” on page 27.
See “Main menu and Sub-menu” on page 28.
OK
CANCEL
DELETE
TEXT CHANGE
COMPUTER2 SELECT
FILTER REMAINING
NOTE:
• See “Replacing the ARF (Auto Rolling Filter)” on
• After you replace the
ARF
,
FILTER REMAINING
should be reset to “0” by pressing the
ENTER
button for
3 seconds.
LAMP RUNTIME
NOTE:
•
LAMP RUNTIME
is a relevant matter for lamp
replacement timing. See “Replacing the Lamp unit” on
page 41.
• When the lamp unit is replaced with the new one
(ET-LAF100), the setting will be reset to “0”.
