Switching on/off the projector
ENGLISH - 37
Basic Operation
Switching on the projector
To use a projection lens that is an optional accessory,
attach the lens before switching on the projector.
(
page 31)
Remove the lens cover first.
1) Connect the power plug to an outlet.
(AC 220 V - 240 V 50 Hz/60 Hz)
2) Press the <ON> side of the <MAIN
POWER> switch to turn on the power.
▶
z
The power indicator <ON (G)/STANDBY (R)>
will light in red, and the projector will enter the
standby mode.
3) Press the POWER ON < > button.
▶
z
The power indicator <ON (G)/STANDBY (R)>
will light in green and the image will soon be
projected on the screen.
Note
z
If the projector is switched on at about 0°C (32°F),
a warm-up period of approximately five minutes
may be necessary until a projection is displayed.
The temperature indicator <TEMP> is lit during the
warm-up period. When the warm-up is completed,
the temperature indicator <TEMP> turns off and the
projection starts. Refer to “Managing the indicated
problems” (
page 102) for the indicator status.
z
If the operating environment temperature is low and
warm-up takes more than 5 minutes, the projector
will judge that a problem has occurred and the
power will automatically be set to stand-by. If this
happens, increase the operating environment
temperature to 0°C (32°F) or higher, turn off the
main power, and then turn on the power again.
z
If [PROJECTOR SETUP] → [STANDBY MODE]
(
page 68) is set to [ECO] on the menu, there
may be a 10 second display lag when the power
is turned on compared to when the setting is
[NORMAL].
z
If the <MAIN POWER> switch was turned <OFF>
during projection the last time that the direct power
off function was used, and the<MAIN POWER>
switch is turned <ON> while the main power plug
connected to the outlet, the power indicator<ON (G)/
STANDBY (R)> will light in green and the image will
soon be projected on the screen.
Making adjustments and
selections
It is recommended that images are projected
continuously for at least 30 minutes before the focus
is adjusted.
4) Press the <FOCUS> button to adjust
the focus of the image roughly.
(
page 39)
5) Set the projection method using
[PROJECTION METHOD] (
page 66)
and [COOLING CONDITION] (
page 67)
on the menu.
▶
z
Refer to “Navigating through the menu”
(
page 44) for the operation of the menu.
6) Press the input selection (<RGB1>,
<RGB2>, <DVI-D>, <VIDEO>,
<S-VIDEO>, <HDMI>) buttons to select
the input signal. (
page 41)
7) Adjust the front, back and sideway tilt
of the projector with the adjustable
feet. (
page 29)
8) Press the <SHIFT> button to adjust the
position of the image. (
page 39)
9) If the input signal is an RGB input
signal, press the <AUTO SETUP>
button. (
page 42)
10) Press the <ZOOM> button to adjust
the size of the image to match the
screen. (
page 39)
11) Press the <FOCUS> button again to
adjust the focus.
12) Press the <ZOOM> button again to
adjust the zoom and the size of the
image to match the screen.
1)
7)
6)
9)
3)
3)
5)
5)
4)
9)
6)
8)
10) 12)
4) 11)
8) 10) 11) 12)
2)
