Position
ENGLISH -
41
Settings
V Position
Shift the projected image position vertically.
Press ▲▼ to select [V Position].
1 )
Press ►
to display the adjustment
2 )
dialog box.
Press ◄► to adjust the level.
3 )
Note
During Computer input signal, [V Position] can be
z
adjusted.
Digital Zoom
Adjust the magnification of the image. Magnification
can be set from 1.0x to 2.0x in 0.1 increments.
Press ▲▼ to select [Digital Zoom].
1 )
Press ►
to display the adjustment
2 )
dialog box.
Press ◄► to adjust the level.
3 )
Note
When the [Digital Zoom] is in the enlarge status, exits the
z
menu screen and the [Zoom] picture will display at the
bottom left of the screen. This indicates the zoom
function is in use.
Under the enlarge status, press ▲▼◄► to move the
z
enlarged image.
If the input signal is changed under the enlarge status,
z
the magnification of [Digital Zoom] will be reset.
V Keystone
This function is used to adjust keystone distortion of
the projected image.
Press ▲▼ to select [V Keystone].
1 )
Press ►
to display the adjustment
2 )
dialog box.
Press ◄► to adjust the level.
3 )
Use the <K/-> (▲▼) buttons on the
z
remote control to adjust.
Operation
Screen image
Press the ▲► on
the remote control
or the ► on the
control panel to
adjust the upper of
the keystone.
Press the ▲► on
the remote control
or the ► on the
control panel to
adjust the bottom of
the keystone.
Note
The adjusted keystone distortion will store automatically
z
even when the signal is interrupted or the AC power cord
is plugged out or turned off the projector.
When the larger amount of keystone correction, the
z
picture quality will degrade and it will get harder to
focus with more correction. Install the projector so the
correction will be as small as possible.
When keystone correction is performed, the screen size
z
will also change.
Part of Closed caption may not be displayed when high
z
compensation values are set in [V Keystone].
Ceiling Mount
This function is used to project the image from a
ceiling-mounted projector.
Press ▲▼ to select [Ceiling Mount].
1 )
Press ►
to display the choosing dialog
2 )
box.
Press ◄► to select the desired item.
3 )
Front
When setting on a desk/floor and
projecting from forward.
Front
Ceiling
When mounting on the ceiling and
projecting forward.
Rear
When setting on a desk/floor and
projecting rear (Using translucent
screen).
Rear
Ceiling
When mounting on the ceiling and
projecting from rear (Using translucent
screen).
