Remote control operation
14 -
E
NGLISH
Loading a saved setting
You can access saved settings instantly. See
“MEMORY LOAD” on page 31.
Select the required setting from
1.
MEMORY 1 - 16
.
Undefined setting will not be displayed.
Press the
2.
ENTER
button to activate the selected
setting.
NOTE:
If you have not saved any settings,
•
MEMORY 1 - 16
will not be displayed.
VIERA Link
You can control some functions of the connected equipment with this projector remote control.
See the operating instructions for more details.
Adjusting the signal condition with a waveform
You can display the image brightness and
contrast level of the input signal with a
waveform. See “WAVEFORM MONITOR” on
page 21.
FULL SCAN
Monitoring the waveform of
brightness and contrast of the whole
image.
SINGLE LINE SCAN
Monitoring the waveform of
brightness and contrast in each
horizontal line of the image.
Displaying the waveform
J
Press the
1.
WAVEFORM MONITOR
button and
display the waveform monitor.
Press the
WAVEFORM MONITOR
button again to
escape from the waveform mode.
Press the
2.
ENTER
button until the required
waveform option is displayed.
In
FULL SCAN
mode, press ▲ ▼ ◄ ► to change
the waveform position.
In
SINGLE LINE SCAN
mode, press ▲ ▼ to select
the required line position.
FULL SCAN(Y)
SINGLE LINE SCAN(B)
FULL SCAN(R)
SINGLE LINE SCAN(G)
FULL SCAN(G)
SINGLE LINE SCAN(R)
FULL SCAN(B)
SINGLE LINE SCAN(Y)
NOTE:
In
•
SINGLE LINE SCAN
mode, the position of the waveform monitor depends on the position of the selected line.
You can display the main menu by pressing the
•
MENU
button and adjust the menu items.
The called up menu items displayed position depends on the position of the waveform monitor.
•
You can activate
•
AUTO ADJUST
of the
WAVEFORM MONITOR
menu by pressing the
DEFAULT
button.
The signal which is lower than 0 % in the waveform will be displayed as same as 0 % on the projected image.
•
While the waveform is displayed, you can not adjust the
•
COLOUR
MANAGEMENT
settings.
Capturing an image
Press the
FREEZE
button to capture the
image, and you can see it as a still picture
while the AV equipment are still running. Press
the
FREEZE
button again to escape and return
to the continuing image.
While displaying the frozen image, you can enter the
AREA SELECT
mode of the
SPLIT ADJUST
menu by
pressing the
ENTER
button. See “SPLIT ADJUST” on
page 22.
Resetting to the factory default settings
You can reset most of the customised
settings to the factory defaults by pressing
the
DEFAULT
button. Display the required
sub-menu or the menu items and press the
button.
NOTE:
Some menu items are not available to reset by
•
pressing the
DEFAULT
button. Adjust each menu item
manually.
