PAN4620 802.15.4 and Bluetooth LE Module
5 Getting Started
Integration Guide Rev. 1.0
Page 33
Next to the Firmware Loader option, the NXP Test Tool 12 comes with
additional functions like a Protocol Analyzer, a Radio Test or an OTA
(Over The Air) Update section. For more information about the Test Tool see
“Freescale Test Tool User’s Guide”.
5.7 Using Thread Example Application
The following requirement must be met:
Two of the PAN4620 evaluation boards are flashed with the software
(
frdmkw41z_wireless_examples_thread_router_eligible_device_freertos
)
1. Open two terminal programs like
HTerm
and connect them to the COM ports of both
nodes. Use the serial configurations for the nodes (like the figures below will show).
2. On the first node enter the command
thr create
and press
Enter
.
Take care that there is always the
CR-LF
option selected at the menu
send on enter
in the section
Input control
of
HTerm
or similar
terminal programs.
Wait till the node has created the Thread network (here with the
ID 0xc26d
).
