Assembling the steam iron
Be sure to assemble the product on a flat and stable surface.
1.
Lay the two ironing boards flat, and align the joints of ironing
board A and ironing board B in the correct direction as
shown in the figure to integrate them.
Be aware of the orientation of the
ironing boards during installation.
3. Fully open the buckles of the telescopic pole sockets on the
back of the ironing board, and lay them flat first and then set
them upright to align with each other as shown in the figure.
2.
After placing the assembled ironing board A/B on the center
of the spread ironing cloth, hang the wire hook of the
ironing cloth on the upper hook
of the ironing board A/B
first, make sure that ironing board A/B is completely
wrapped by the ironing cloth, tighten the pull rope of the
ironing cloth, and then twine the tightened pull rope around
the lower hook
of ironing board A/B and clamp it in center.
Lower hook
Upper hook
Wire
hook
Pull rope
4.
As shown in the figure, insert the two telescopic poles
into the telescopic pole sockets on the back of the ironing
board A/B. Be aware of the orientation of the telescopic
poles and insert the telescopic poles down to the end.
Lock buckle 2 as shown in the figure.
Buckle 1
Buckle 2
Buckle 2
Iron holder
Hose hook
Ironing
board A
Ironing board B
10
11
English
English
5. Lay the telescopic poles down, and then lock buckle 1 as
shown in the figure.
6. Use both hands to hold the telescopic poles from the back
of the entire part combining the ironing board with the
telescopic rod to lift the part up.
Buckle 1
7.
As shown in the figure, insert the lower end of the telescopic
pole into the telescopic pole hole on the power base in the
correct direction until a “click” is heard.
8. Insert the hanger fixer into the socket on the top of the
ironing board in the correct direction as shown in the figure.
Front of the ironing board
The power base
side printed with
“Panasonic” mark
Iron holder
Summary of Contents for NI-GWF150
Page 12: ...MEMO MEMO ...
