23
Maintaining the pre-motor
fi
lter
Remove the dust bag. (see replacing the dust bag)
Remove pre-motor
fi
lter from its slot, wash gently with water and then allow
it to dry in shaded area.
Replace all parts to their original positions.
If the dust bag is not properly installed, the dust cover cannot be closed.
1.
2.
3.
1.
2.
3.
Speci
fi
cations
MC-CG524
MC-CG522
Power source
230 V ~ 50 Hz
Max input
1400 W
1300 W
Nominal input
1300 W
1250 W
Dimensions (W x L x H)
304 mm x 450 mm x 240 mm
Net weight
4.5 k
g
Extension wands
Telescopic
Floor nozzle
√
Crevice nozzle
√
Dusting brush
√
Class with respect to protection against electric shock:
*
Cleaning the outside of the appliance
Clean the outside of the appliance with a soft cloth.
Cleaning the
fl
oor nozzle
Use an old tooth brush or similar tool to clean any dirt or lint from the brush.
MC-CG524
MC-CG522
CAUTION
Do not wash the
fl
oor nozzle with water.
MAINTENANCE
TROUBLESHOOTING
Please check the following
fi
rst if you have any problems.
Problem
Solution
The appliance does not switch on.
Check if the plug is connected
fi
rmly and the socket outlet is working normally.
If a thermal cut-out device has activated, wait approximately 60 minutes until it has reset.
−
−
The mains lead does not come out.
Rewind and pull out the mains lead repeatedly while pressing the cord rewind pedal without using
excessive power.
−
The mains lead does not fully rewind.
Pull the mains lead out 2 m to 3 m and then press the cord rewind pedal to rewind the mains lead
while holding the plug.
−
Suction power has decreased.
Check if the dust bag is full.
Check for blockages in hose, telescopic wand, nozzles and pre-motor
fi
lter. Then clean those parts as
necessary.
−
−
If the problem cannot be solved, please contact your local customer service centre. The contacts can be found in “GUARANTEE”, the separate paper which has
been attached with the appliance.
WARNING
Remove the plug from the socket outlet before cleaning or maintaining the
appliance.
CAUTION
Do not use detergent or any other cleaning liquids.
−
−
CAUTION
Attach the pre-motor
fi
lter correctly to avoid damaging motor.
Replacing the exhaust
fi
lter
Replace the exhaust
fi
lter once a year.
Detach two tabs of body cover from the rear side and replace the
fi
lter with a new one.
Put the body cover back to the main body.
Flat surface
face down
MC-CG522
MC-CG524
or
English
