6. Shutter and Drive Settings
200
∫
Changing the settings for [Single/Burst Settings], [Step] and [Sequence] in Auto
Bracket
1
2
Press
3
/
4
to select [Single/Burst Settings], [Step] or [Sequence] and then
press [MENU/SET].
3
Press
3
/
4
to select the setting and then press [MENU/SET].
• You can take one picture at a time when set to [
].
• You can continuously take pictures up to set numbers when set to [
].
• Exit the menu after it is set.
• When taking pictures using Auto Bracket after setting the Exposure Compensation value, the
pictures taken are based on the selected Exposure Compensation value.
Not available in these cases:
• Auto Bracket is disabled in the following cases.
– [Glistening Water]/[Glittering Illuminations]/[Handheld Night Shot]/[Soft Image of a Flower]
(Scene Guide Mode)
– [Rough Monochrome]/[Silky Monochrome]/[Miniature Effect]/[Soft Focus]/[Star Filter]/
[Sunshine] (Creative Control Mode)
– When White Balance Bracket is set
– When recording motion pictures
– When recording using the flash
– When recording with the shutter speed set to [B] (Bulb)
– When recording with [iHandheld Night Shot]
– When [HDR] is set to [ON]
– When using [Multi Exp.]
– When [Simultaneous record w/o filter] of [Filter Settings] is set to [ON]
>
[Rec]
>
[Auto Bracket]
[Single/Burst Settings]
[
] (single)
[
] (burst)
[Step]
[3•1/3] (3 pictures)
[3•2/3] (3 pictures)
[3•1] (3 pictures)
[5•1/3] (5 pictures)
[5•2/3] (5 pictures)
[5•1] (5 pictures)
[7•1/3] (7 pictures)
[7•2/3] (7 pictures)
[7•1] (7 pictures)
[Sequence]
[0/
`
/
_
]
[
`
/0/
_
]
MENU
