Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 67 / 240

67
2-7 Construction of System
The following figure shows the construction sample of the system.
ABCD
ABCD
ABCD
BCD
a
u
w
y
q
i
o
t
r
e
1!
No. Description Installation and control sample
q
Laser marker head -
w
Laser marker controller -
e
PC for laser marker setting/monitoring -
r
Protective enclosure -
t
Laser protection shutter for workpiece
gateway
Construct a control system which will separate (cut off) the laser beams
or shut off the laser power when it is opened.
y
Emergency stop button Construct a control system for shutting off the laser power source when
it is opened.
u
Safety switch
i
Door for the maintenance
o
Safety relay unit or safety PLC, etc. Connect both INTERLOCK 1 (X16, X17) and INTERLOCK 2 (X18,
X19) of the laser marker to the devices
t
to
i
using the relay output
terminal of the safety relay unit or the safety PLC.
Besides INTERLOCK terminals, it can also be connected to other I/O signals
such as LASER STOP terminals with the devices
t
to
i
depending on
the control specifications.
a
Laser radiation warning light To indicate the laser marker status, connect the output signals such
as ALARM OUT (Y15), LASER SUPPLY OUT (Y20) or LASING OUT
(No.40) to the light.
s
Dust exhauster Place the intake vent of the exhauster as close as possible to the
marking position of the workpieces.
ワㄐㄕㄊ㄄ㄆ
• INTERLOCK terminals (X16, X17 and X18, X19) are connected to the operating coil of the internal contactor in the
controller. Connect INTERLOCK (+) and INTERLOCK (-) in the I/O terminal with the non-voltage contact (dry contact)
such as a relay or a switch. Do not connect with the voltage contact such as a transistor.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• When constructing a system compatible to ISO11553-1/ISO13849-1, construct the redundant interlock system by using
both INTERLOCK 1 (X16, X17) and INTERLOCK 2 (X18, X19) connected to safety PLC or safety relay unit to shut off the
laser power supply in accordance with the standards.
ME-LPRH-SM-3