24 System settings
The new settings will be updated in the laser marking system.
Related topics
24.14 Specify Ethernet communication settings
To establish an Ethernet connection, make the network settings in Laser Marker NAVI smart
according to the requirements of your network environment.
• The Ethernet interface can be connected simultaneously via a hub or a router to a PC for
configuration or command control, to an external device (e.g. PLC or PC) for command
control, and to a specific imagechecker.
• Ethernet communication should be performed in a secure network environment.
1. Establish an online connection between your PC and the laser marking system.
2. Go to the “System settings” screen and select “Communication”.
3. Set the Ethernet communication settings according to your network environment.
Even if the values for the IP address and the subnet mask are within the configurable
range, they may be invalid because of their combination.
• “IP address”: 1.0.0.0–223.255.255.255 (do not use 127 for the first octet)
Initial setting: 192.168.1.5
Enter an IP address, which is not already used by the laser marking system or by the
PC.
• “Subnet mask”: 128.0.0.0–255.255.255.254
Initial setting: 255.255.255.0
• “Default gateway”: 1.0.0.0–223.255.255.255 (do not use 127 for the first octet)
Initial setting: 0.0.0.0 (unspecified)
• “Port for PC configuration software”: 1025–65534 (do not use 9090)
Initial setting: 9093
• “Port for communication commands”: 1025–65534 (do not use 9090)
Initial setting: 9094
Set different port numbers for “Port for PC configuration software” and “Port for
communication commands”.
• “MAC address”: Displays the MAC address.
4. Select “Apply to laser marking system” in the ribbon.
5. Disconnect the online connection with the laser marking system.
266
ME-NAVIS2-OP-1
