Panasonic LP-M Series, Operation Manual, Page: 185 / 308

185
Description
8 Line Speed (Except LP-SxxxW type) :
Used at measurement of marking period.
It is indicated when the moving direction in the trigger setting is set to other than “still”.
Measure the line speed in consideration of the line speed of the flying object.
Setting Range
0.060 to 170.000 m/minutes (LP-M500 / LP-Z130)*
0.060 to 240.000 m/minutes (LP-S500)*
9 Fly. Obj. Wait (Flying Object Wait) (Except LP-SxxxW type) :
Used at measurement of marking period.
Waiting period for marking corresponding to the line speed for flying object marking.
It is indicated when the moving direction in the trigger setting is set to other than “still”.
Setting Range 0.00 to 500.00 ms
10 Start Point :
11 End Point :
With this function, the timing for turning on the laser at the starting or ending point is adjusted.
The smaller the value is, the darker (deeper) the marked character at the starting or ending point is.
Setting Range -100 to 100
Initial Value of
Start Point 0 (LP-MA00 / LP-S series / LP-Z series)
-10 (LP-M series (except LP-MA00))
Initial Value of
End Point
0
Light (Shallow) Dark (Deep) Proper
Setting value
Light (Shallow)
Small
Dark (Deep)
Large
Optimal
Notice
• Too small value for the adjustment of start/end point may be the cause of chipped character.
12 DETAIL :
They will provide fine adjustment of marking quality.
For details of setting item, refer to “2-11-3 Detail Adjustment (Laser Setting)” (P.191).
* For the setting range of the other model, refer to “Input Setting Value by Series” (P.296).
ME-LPMSZ-OP-7