Panasonic LP-M Series, Operation Manual, Page: 135 / 308

135
„
Coordinate System (World Coordinate / Local Coordinate)
When marking to 3D figure (slope, cylinder, cone, sphere), the compatible coordinate is determined depending on the 3D
figure (layer), and marking content (character, barcode, logo. etc.).
World coordinate : The coordinate system that sets the area center to the origin point and specifies the center
position of the 3D work shape (layer).
Local coordinate : The coordinate system that sets the center of the 3D work shape to the origin point and
specifies the marking position of characters, bar codes, and logos.
When setting each center position of the 3D figure (layer: slope), center position X: 10 mm, center position Y: 10 mm, and
center position Z: 8 mm, these positions are set on the world coordinate shown as follows.
X
Y
Z
X
Y
＋
Z’
Y’
X’
＋
－
＋
－
＋ －
10mm
8mm
10mm
Center of 3D Figure
(Original Point of Local
Coordinate)
Original Point of
World Coordinate
Rotation
Direction
Rotation Angle X:
+45 degree
„
Coordinate setting for marking content : Local coordinate
When setting the starting position of the marking content, X position: -4 mm, Y position: -1 mm, each setting condition is set
on the local coordinate as follows.
ABCD
X
Y
Original Point of
Local Coordinate
Starting Position
3D Figure (Slope)
-1 mm
-4 mm
ME-LPMSZ-OP-7