Panasonic LP-400 Series, External Control Manual

Page: 125 / 180

125
⿎ External offset condition : OFC
Sets input conditions of “External Offset Function” to switch coordinates using I/O input.
• Setting / Readout data of external offset condition
STX OFC
Sub
command
[External offset]
1-byte
(Check
sum)
Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of external offset condition
STX OFC R (Check sum) Delimiter
Name Data length [byte] Description Remarks
External offset 1
“0”: no use
“1”: low 4-bit
“2”: low 8-bit
⿎ External offset coordinates : OFS
Sets offset coordinates used for “External Offset Function” to switch coordinates using I/O input.
• Setting / Readout data of external offset coordinates
STX OFS
Sub
command
[Parallel data No.] [X offset] [Y offset] [
θ
offset]
26-byte
(Check
sum)
Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of external offset coordinates
STX OFS R
[Parallel data No.]
3-byte
(Check
sum)
Delimiter
Name
Data length
[byte]
Description Remarks
Parallel data No. 3 “000”–“255”
The parallel data number in which offset
is set is indicated.
X offset 8
Model type* Setting range [mm]
LP-V10 “-045.000”–“+045.000”
LP-4x0 “-055.000”–“+055.000”
LP-4x5/LP-V15 “-080.000”–“+080.000”
LP-4x1/LP-W “-027.500”–“+027.500”
Y offset 8
θ
offset 7 “-180.00”–“+180.00” [°] The rotation offset is indicated.
* For the detail of the model type, refer to “Target laser marker” (P.8).
ME-LP400V-EX-6