Status Message
Setting
Description
Value Range
Default
Status Message
View a list of status messages for the
unit. Press
[ ]
and
[ ]
to display the
various messages.
—
—
Network Settings
IMPORTANT
We recommend configuring these settings with your administrator or dealer. Network settings can also be
configured through Web user interface programming (Page 58). Contact your administrator or dealer for
further information.
Network
Setting
Sub-Setting
Description
Value Range
Default
IP Address Mode
—
Specify the IP address mode
to use.
IPv4 only
IPv6 only
Dual stack
Dual
stack
IPv4
Enable DHCP
Enable or disable DHCP for
IPv4.
Yes, No
Yes
IP Address
If DHCP is not enabled, you
must specify the IP address.
xxx.xxx.xxx.xxx
—
Subnet Mask
If DHCP is not enabled, you
must specify the subnet
mask.
xxx.xxx.xxx.xxx
—
Default Gateway
If DHCP is not enabled, you
must specify the default
gateway.
xxx.xxx.xxx.xxx
—
Auto DNS
Enable or disable Auto DNS
for IPv4.
Yes, No
Yes
DNS1
If Auto DNS is not enabled,
you can specify the primary
DNS server IP address.
xxx.xxx.xxx.xxx
—
DNS2
If Auto DNS is not enabled,
you can specify the
secondary DNS server IP
address. Leave blank if a
secondary DNS server is not
used.
xxx.xxx.xxx.xxx
—
IPv6
Enable IPv6
DHCP
Enable or disable DHCP for
IPv6.
Yes, No
Yes
Allow Auto
Configuration
Enable or disable auto
configuration for IPv6.
Yes, No
Yes
Document Version 2014-11
Operating Instructions
49
Customizing the Telephone
