NOM_DELAY_n
Parameter Name Example
NOM_DELAY_1
,
NOM_DELAY_2
, …,
NOM_DELAY_6
Value Format
Integer
Description
Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range
1–7 (
´
10 ms)
Note
•
This setting is subject to the following conditions:
–
This value must be greater than or equal to "
MIN_DELAY
"
–
This value must be less than "
MAX_DELAY
"
Default Value
2
Web User Interface Reference
RTP_PORT_MIN
Value Format
Integer
Description
Specifies the lowest port number that the unit will use for RTP packets.
Note
•
If port numbers are specified in
[Channel 1–25]
in
in the Web user interface, this
setting is ignored and the corresponding external RTP port is
enabled.
Value Range
1024–48750 (even number only)
Note
•
The value for this setting must be less than or equal to
"
RTP_PORT_MAX
" - 400.
•
Changing this setting may affect the number of simultaneous
calls that can be made. Therefore, when setting this parameter,
be aware that the maximum number of necessary ports can be
calculated as shown below:
No. of lines
´
No. of channels
´
2
´
10 (No. of terminals)
Default Value
16000
Web User Interface Reference
Minimum RTP Port Number (Page 114)
RTP_PORT_MAX
Value Format
Integer
234
Administrator Guide
Document Version 2012-06
5.6.2 RTP Settings
Summary of Contents for KX-UT248-B
