Panasonic KX-TVP200BX, Service Manual

Page: 292 / 448

4-78
System Administrator
4.5.6 Hardware Settings
Value Range
(default)
1. 100 msec
2. 300 msec
3. 600 msec
4. 900 msec
(100)
1. None
2. 6.5 msec
3. 150 msec
4. 300 msec
5. 450 msec
6. 600 msec
(6.5)
1–8 sec
(2)
1. DTMF
2. Pulse 10 pps
3. Pulse 20 pps
(DTMF)
PBX Type
p.4-79
Parameter
Description/Function
Reference
Flash Time
CPC Signal
Disconnect
Time
Dial Mode
Specifies the length of time that the hookswitch
must be pressed before the PBX recognizes it as a
flash hook signal. See the manuals of PBX to
determine the correct value.
[NOTE]
You can select only “1. 100 msec”.
Specifies the minimum time required to detect a
break in the CPC (Calling Party Control) signal
from the PBX. The VPS detects that the line has
been disconnected when there is a break of the
CPC signal.
Specifies the amount of time that the line is
temporarily unavailable to access after a call has
ended.
Specifies dial mode for DTMF or Pulse.
If you specify Pulse, pulse speed (10/20 pps) must
be selected.
[NOTE]
You can not select “3. Pulse 20 pps”.
Note: The “Flash” means the register recall in this manual.
4.5.6.3 PBX Interface Parameters
Three types of parameters are used to program the VPS for optimal signaling and
performance with your PBX.
System Administration Top Menu
→
1
→
6
→
3
Program – Hardware – PBX Interface Menu
1. Dialing Parameters
2. Inband Signaling
3. Digit Translation Table
SELECT ITEM AND PRESS RETURN–KEY