Panasonic KX-TVM50, Installation Manual

Page: 117 / 200

4.6 KX-TA Series PBX Programming for APT Integra-
tion
Programming procedures and availability may vary by country/area, software version, etc. Refer to the
documentation included with the PBX or consult your dealer for more information.
Note
•
The following procedures can also be used for KX-TE series PBXs if programming via the Manager
Extension is preferred.
•
For KX-TES824/TEM824, PBX software version 1.0.44 or higher is required for APT Integration.
Consult your dealer for more information.
It is important that the PBX has the proper software level to allow APT Integration with the VPS. Follow the
procedures below to confirm the software level, then complete the required programming before starting up
the VPS.
All of the following procedures must be completed after entering system programming. Refer to the
KX-TA series Installation Manual for instructions on how to enter the system programming mode.
1.
Using the Manager Extension, check the software version of the KX-TA series PBX using System Program
[998].
Example:
Y581J000421 (XX)
The underlined digits represent the software production date code (year, month, day). For APT Integration,
the production date must be 000421 or later.
If the software version of the PBX is lower than this, consult your dealer.
From the
SYS-PGM NO ? screen:
a.
Enter [998] .
b.
Press the NEXT button (SP-PHONE). The PBX displays the ROM version and the date it was created.
2.
Set the date and time using System Program [000] .
The date and time are automatically synchronised between the VPS and the PBX during Quick Setup.
3.
Set extension numbering using System Program [009] .
4.
Assign the voice mail port. This program tells the PBX which jacks will be connected to the VPS and allows
the PBX to send the proper APT Integration information to those ports.
Jack 07, or jacks 07 and 08 can be assigned for the VPS1 as the voice mail port. Jack 15, or jacks 15 and
16 can be assigned for the VPS2.
Extension
group 8
KX-TE or
KX-TA
Series PBX
15
16
Port 1
Port 2
VPS 2
7
8
Port 1
Port 2
VPS 1
Extension
group 7
From the SYS-PGM NO ? screen:
a.
Enter [130] (for VPS1) or [131] (for VPS2).
b.
Press the NEXT button (SP-PHONE).
Screen output:
Disable
c.
Press the SELECT button (AUTO ANS).
Screen output:
Port 7
or
Port 15
Document Version 2.1 2008/04 Installation Manual 117
4.6 KX-TA Series PBX Programming for APT Integration