Cyrillic character table (
)
z
y
1
2
3
4
5
6
7
8
9
Error messages
Display message
Cause/solution
Base no power
or
No link.
Reconnect
AC adaptor.
R
Confirm the base unit’s AC adaptor is connected to the unit
and the power outlet correctly.
R
The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset’s registration may have been cancelled.
Re-register the handset (page 26).
Check
Phone Line
R
The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 8).
Memory Full
R
The phonebook memory is full. Erase unwanted entries
(page 17).
R
The call block list memory is full. Erase unwanted entries
(page 24).
R
The maximum number of base units (4) is already registered
to the handset. Cancel unused base unit registrations from
the handset (page 26).
Use
rechargeable
battery.
R
A wrong type of battery such as alkaline or manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 6.
You must first
subscribe
to Caller ID.
R
You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.
32
Useful Information
