2
MbN
:
“
Range of Numbers
”
a
M
OK
N
3
M
MENU
N
a
MbN
:
“
Add
”
a
M
OK
N
4
Enter the desired number (2-8 digits).
R
To erase a digit, press
M
CLEAR
N
.
5
M
OK
N
a
M
OFF
N
Blocking incoming calls that
have no phone number
You can block calls when no phone number is
provided, such as private callers.
1
M
MENU
N#240
2
MbN
: Select the desired setting.
a
M
OK
N
3
M
OFF
N
Viewing/editing/erasing call
block numbers
1
M
MENU
N#217
2
MbN
:
“
Single Number
”
or
“
Range of
Numbers
”
a
M
OK
N
3
MbN
: Select the desired entry.
R
To exit, press
M
OFF
N
.
4
To edit a number:
M
EDIT
N
a
Edit the number.
a
M
OK
N
a
M
OFF
N
To erase a number:
M
ERASE
N
a
MbN
:
“
Yes
”
a
M
OK
N
a
M
OFF
N
Note:
R
When editing, press the desired dial key to
add digits and press
M
CLEAR
N
to erase
digits.
Erasing all call block numbers
1
M
MENU
N#217
2
MbN
:
“
Single Number
”
or
“
Range of
Numbers
”
a
M
OK
N
3
M
MENU
N
a
MbN
:
“
Erase All
”
a
M
OK
N
4
MbN
:
“
Yes
”
a
M
OK
N
5
MbN
:
“
Yes
”
a
M
OK
N
a
M
OFF
N
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby’s room, for example) will
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
R
You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
R
This feature should not be used as a
substitute for a medical or caregiver’s
supervision. It is the caregiver’s
responsibility to stay close enough to
handle any eventuality.
Note:
R
Both the monitored and monitoring
handsets must select the same base unit in
order to use the baby monitor feature
(page 34).
R
If the unit is connected to a PBX system,
you cannot set the baby monitor.
R
During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R
The monitored handset never rings while it
is being monitored.
If the base unit is placed near the
monitored handset, we recommend turning
off the base unit ringer volume (page 24).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).
To monitor with a handset
The internal baby monitor feature is available
between handsets in the same radio cell.
30
Programming
TGD32xAL(en)_1103_ver021.pdf 30
3/11/2015 1:59:53 PM
