Programming
31
Helpline Tel. No.: U.K. 0844 844 3898 Ireland 01289 8333
L
The next step must be completed
within 90 seconds.
3
Handset:
M
s
Wait until
“
Base PIN
”
is
displayed.
s
Enter the base unit PIN
(default:
“
0000
”
).
s
M
L
If you forget your PIN, see page 45.
L
When the handset has been registered
successfully,
w
is displayed.
Note:
L
While registering,
“
Base in
registering
”
is displayed on all
registered handsets.
L
When you purchase an additional handset,
refer to the additional handset’s installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
1
(middle soft key)
(
131
L
All handsets registered to the base
unit are displayed.
2
{
r
}
: Select the handset you want to
cancel.
s
M
3
{
r
}
:
“
Yes
”
s
M
L
A confirmation tone sounds.
L
The handset does not beep when
cancelling its own registration.
4
{i
c
}
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
L
Before registering the repeater to this base
unit, you must turn the repeater mode on.
L
Do not use more than one repeater at a
time.
Setting the repeater mode
1
1
(middle soft key)
(
138
2
{
r
}
: Select the desired setting.
s
M
s
{i
c
}
Note:
L
After turning the repeater mode on or off,
_
is displayed on the handset momentarily.
This is normal and the handset can be used
once
w
is displayed.
Registering the DECT repeater (KX-
A405) to the base unit
Note:
L
Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Proceed with the operation for your
model.
■
KX-TG8051
Press and hold
{x}
for about 5
seconds. (No registration tone)
■
KX-TG8061/KX-TG8062/KX-TG8063
Press and hold
{x}
for about 5
seconds, until the registration tone
sounds.
L
The next step must be completed
within 90 seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until
the
&
indicator lights green.
3
Base unit:
To exit the registration mode, press
{x}
.
L
The registration tone stops.
(KX-TG8061/KX-TG8062/
KX-TG8063)
TG8051_8061E(e).book Page 31 Monday, January 24, 2011 4:37 PM
