indicator
Status
Meaning
Green
(On)
Signal strength of the base
unit is strong.
Amber
(On)
Signal strength of the base
unit is weak.
Red
(On)
Out of base unit range.
Off
R
The unit is not being used.
R
The power is off.
Installation
1
Connect the unit.
R
Use only the supplied Panasonic AC
adaptor PQLV219AL.
Press plug firmly.
Hook
(220-240 V AC, 50/60 Hz)
R
When the unit is turned on, the
indicator and
indicator light amber
for about 2 seconds.
2
Confirm that the
indicator and
indicator light green. (The unit is ready
for use.)
R
If the indicators do not light green,
re-position the unit in a place where
the indicators light green.
Note:
R
The AC adaptor must remain connected at
all times. (It is normal for the adaptor to feel
warm during use.)
R
The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of
the adaptor may cause it to become
disconnected.
R
The unit can support a maximum of 3
handsets at a time.
Setting the repeater mode
This repeater is pre-registered to the base unit
and the default setting of repeater mode is
“
On
”
. You do not need to change this setting
for initial use.
1
M
MENU
N
#138
2
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Note:
R
After turning the repeater mode on or off,
is displayed on the handset
momentarily. This is normal and the
handset can be used once
is displayed.
Wall mounting
Note:
R
Make sure that the wall and the fixing
method are strong enough to support the
weight of the unit.
R
Drive the screws (not supplied) into the wall.
37 mm
Screws
Wall mounting template
37 mm
68
DECT repeater
TG78xxAZ(en)_0217_ver521.pdf 68
17/2/2016 11:47:39 AM
