Sub-menu 1
Sub-menu 2
Settings
Code
Change language
(Display)
–
<
English
>
Français
#110
Main menu:
“
Cust. Support
”
Operation
Code
Displaying customer support Web address.
#680
–
*1 If you program these settings using one of the units, you do not need to program the same
item using another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select
“
Caller ID auto
”
. To turn this feature off, select
“
Manual
”
. (Call Display subscribers only)
To use this feature, set the date and time first (page 13).
*4 If you subscribe to a distinctive ring service, select a tone (tone 1 to 3). If you select a
melody, you cannot distinguish lines by their ringers.
*5 If you select one of the melody ringer tones, it will continue to play for several seconds even
if the caller has already hung up. You may either hear a dial tone or no one on the line when
you answer the call.
*6 The preset melodies in this product are used with permission of © 2009 Copyrights Vision
Inc.
*7 Turn this feature off if you prefer not to hear key tones while you are dialing or pressing any
keys, including confirmation tones and error tones.
*8 If you subscribe to a Call Display service and want to view the caller’s information after lifting
up the handset to answer a call, turn off this feature.
*9 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
*10 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to
“
A
”
if telephone line condition is not good.
*11 This setting is available when you have the key detector (KX-TGA20). Read the installation
guide for more information on the key detector.
*12 For models with supplied key detectors, the display shows “
1:
Detector1
”.
*13 If you register 2 or more key detectors.
*14 If you have 2 or more key detectors.
Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
R
Set the date and time beforehand
(page 13).
Handset
1
M
MENU
N#720
30
Programming
TG684xC(en)_1220_ver013.pdf 30
2012/12/20 14:59:07