Programming
24
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
3
{V}
/
{^}
:
“
Register H.set
”
i
M
4
Base unit:
Proceed with the operation for your
model.
■
KX-TG6411/KX-TG6412/
KX-TG6413
Press and hold
{x}
for about 5
seconds. (No registration tone)
■
KX-TG6421/KX-TG6422/
KX-TG6423/KX-TG6424
Press and hold
{x}
for about 5
seconds, until the registration
tone sounds.
L
If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L
The next step must be completed
within 90 seconds.
5
Handset:
Wait until
“
Base PIN
”
is displayed.
i
Enter the base unit PIN (default:
“
0000
”
).
i
M
L
If you forget your PIN, see page
41.
L
When the handset has been
registered successfully,
w
stops
flashing.
Note:
L
When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored to the
base unit. This allows the handset to end
its wireless connection with the system.
1
8
(middle soft key)
2
{V}
/
{^}
:
“
Base Unit Setup
”
i
M
3
{
3
}{
3
}{
5
}
4
{V}
/
{^}
:
“
Cancel Register
”
i
M
L
The numbers of all handsets
registered to the base unit are
displayed.
5
Select the handset(s) you want to
cancel by pressing the desired
handset number.
i
M
L
The selected handset number(s)
flashes.
L
To cancel a selected handset
number, press the number again.
The number stops flashing.
6
{V}
/
{^}
:
“
Yes
”
i
M
L
A confirmation tone sounds as
each handset number
disappears.
L
The handset does not beep when
cancelling its own registration.
7
{ih}
Increasing the range of the
base unit
You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 4. Contact your
Panasonic dealer for details.
Important:
L
Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L
Do not use more than one repeater at
a time.
Setting the repeater mode
1
8
(middle soft key)
2
{V}
/
{^}
:
“
Base Unit Setup
”
i
M
3
{V}
/
{^}
:
“
Repeater
”
i
M
4
{V}
/
{^}
: Select the desired setting.
i
M
i
{ih}
TG6411-6421E(e).book Page 24 Tuesday, December 16, 2008 7:54 AM
