Panasonic KX-TG4221N, Service Manual

Page: 54 / 87

54
KX-TG4221N/KX-TG4222N/KX-TG4223N/KX-TG313SK/KX-TG4224N/KX-TG4225N/KX-TGA421N
12.5.1.2. Handset
First, operate the PC setting according to The Setting Method of JIG (P.48).
Then download the appropriate data according to the following procedures.
Note:
(*2) WW: country code, XXX: revision number
“XXX” vary depending on the country version. You can find them in the batch file, PNZZ- mentioned in
The Setting Method of
JIG (P.48).
Items How to download/Required adjustment
EEPROM (IC3) Adjusted parameter data is
stored in memory.
(country version batch file,
default batch file, etc.) 1) Default batch file: Execute the command “default.bat”.
2) Default batch file (remaining): Execute the command
“TGA421_DEF_RevXXX.bat”. (*2)
3) Country version batch file: Execute the command
“TGA421_WW_RevXXX.bat”.(*2)
4) Clock adjustment
5) 2.35 V setting and battery low detection
Battery Monitor Check - 1) Apply 2.25 V between BATT+ and BATT-.
2) Execute the command
sendchar PAD
sendchar LED 0
sendchar CRX 0 1
sendchar AD1
It assumes that the return value is XX.
a) 6c XX 71: No need to adjust
b) XX: 6A ~ 6B: Need to adjust
XX: 72 ~ 74: Need to adjust
Write AD value of 2.25 V to EEPROM.
ex) read data: XX = 6A, write data:YY = 6A
read data: XX =73, write data: YY = 73
EEPROM = 0009 (Low Voltage) write “YY“
Execute the command “wreeprom 00 09 01 YY“.
EEPROM = 000A (No Voltage) write “YY - 1D“
Execute the command “xwreeprom 00 0A 01 ZZ“.
Note:
No Voltage writing data limit is “00“.
c) XX: 00 ~ 69: Reject
XX: 75 ~ FF: Reject
Battery Low Confirmation - 1) Apply 2.40 V between BATT+ and BATT-.
2) Confirm that there is no flashing of Battery lcon.
3) Apply 2.25 V ± 0.08 V between BATT+ and BATT-.
4) Confirm that there is flashing of Battery lcon.
Battery Clock Adjustment
(X1)
CLK 1) Apply 2.6 V between BATT+ and BATT- with DC power.
2) Input Command “sendchar sfr“, then you can confirm the current value.
3) Check X’tal Frequency. (10.368 MHz ± 100 Hz).
4) If the frequency is not 10.368 MHz ± 100 Hz, adjust the frequency of CLK exe-
cute in the command “sendchar sfr xx xx (where xx is the value)“ so that the reading
of the frequency counter is 10.368000 MHz ± 5 Hz.