Innovation, Science and
Economic Development Canada
Notices and other information
NOTICE:
This equipment meets the applicable Innovation,
Science and Economic Development Canada Terminal
Equipment Technical
Specifications. This is confirmed by
the registration number. The abbreviation, “ISED:”,
before the registration number signifies that registration
was performed based on a Declaration of Conformity
indicating that Innovation, Science and Economic
Development Canada technical specifications were met.
It does not imply that Innovation, Science and Economic
Development Canada approved the equipment.
Users should ensure, for their own protection, that the
electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system,
if present, are connected together. This precaution may
be particularly important in rural areas.
NOTICE:
The
Ringer Equivalence Number
(REN) assigned
to each terminal device provides an indication of the
maximum number of terminals allowed to be connected
to a telephone interface. The termination on an
interface may consist of any combination of devices
subject only to the requirement that the sum of
the Ringer
Equivalence Numbers of all the devices
does not exceed 5.
The Ringer Equivalence Number (REN) of
this unit:
(found on the bottom of the unit).
NOTICE:
This device complies with Innovation, Science and
Economic Development Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation of the
device.
Privacy of communications may not be ensured when
using this telephone.
RF Exposure Warning:
L
This product complies with ISED radiation exposure
limits set forth for an uncontrolled environment.
L
To comply with ISED RF exposure requirements,
the base unit must be installed and operated
20 cm (8 inches) or more between product and
all person’s body.
L
This product may not be collocated or operated
in conjunction with any other antenna or transmitter.
L
The handset may be carried and operated with only
the specific provided belt clip. Other non-tested belt
clips or similar body-worn accessories may not
comply and must be avoided.
Some cordless telephones operate at frequencies that
may cause interference to nearby TVs and VCRs.
To minimize or prevent such interference, the base of
the cordless telephone should not be placed near, or on
top of, a TV or VCR. If interference is experienced, move
the cordless telephone further away from the TV or VCR.
This will often reduce, or eliminate, interference.
Charge only mode
The charge only mode is the dedicated mode to charge
the backup batteries of the base unit. Do not use this
mode if it is unnecessary because all functions except
the base unit’s battery charge is disabled with this
feature on. Leave all the registered handsets on the
chargers during use of the charge only mode.
n
To activate the charge only mode:
1
Disconnect the telephone line cord, the AC
adaptor plug, and remove the batteries from the
base unit with the corded handset placed on the
cradle.
2
Press and hold
3
,
MZN
, and
M
HOLD
N
at the
same time, then insert the AC adaptor plug to the
base unit.
Keep on pressing these keys until:
– a beep tone sounds, and
–
and the SP-PHONE indicator once turn on
and off.
3
Release these keys.
R
LCD turns off.
4
Insert batteries.
R
The batteries are started to be charged.
For assistance, visit www.panasonic.ca/english/support
75
Useful Information
TG153CSK(en)_0422_ver021.pdf 75
2016/04/22 14:54:46
