Useful Information
19
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section,
disconnect the base unit’s AC adaptor and turn off the handset, then
reconnect the base unit’s AC adaptor and turn on the handset.
Problem
Cause/solution
w
is flashing.
L
The handset is too far from the base
unit. Move closer.
L
The base unit’s AC adaptor is not
connected. Check the connections
(page 5).
L
You are using the handset or base unit
in an area with high electrical
interference. Re-position the base unit
and use the handset away from
sources of interference.
L
The handset registration is cancelled.
Register the handset to the base unit
(page 21).
I cannot make or receive
calls.
L
The base unit’s AC adaptor or
telephone line cord is not connected.
Check the connections.
L
The call bar feature is turned on. Turn it
off (page 14).
L
You dialled a call restricted number
(page 15).
L
The key lock feature is turned on. Turn
it off (page 10).
L
The dialling mode may be set
incorrectly. Change the setting
(page 9).
The unit does not ring.
L
The ringer volume is turned off. Adjust
the ringer volume (page 13).
The handset display is
blank.
L
The handset is not turned on. Turn the
power on (page 6).
The handset will not turn
on.
L
Make sure that the batteries are
installed correctly (page 6).
L
Fully charge the batteries (page 7).
I have changed the
display language to a
language I cannot read.
L
Change the display language (page 9).
A busy tone is heard
when
{C}
is pressed.
L
The handset is too far from the base
unit. Move closer and try again.
Problem
Cause/solution
TG1311_1312_1313EG(e).book Page 19 Tuesday, October 21, 2008 5:04 PM
