Panasonic KX-TDE110, Installation Manual

Page: 127 / 192

3.9 Connection of 2.4 GHz Portable Stations
Installation Manual 127
3.9.2 Procedure Overview
When connecting the wireless system, use extreme care in conducting the site survey. An incorrectly
performed site survey can result in poor service area, frequent noise, and disconnection of calls.
1. Investigate the installation site
Refer to "3.9.3 Site Planning".
a.
Obtain a map of the CS installation site.
b.
Identify the service area required by the user on the map.
c.
Plan the location of each CS, taking account of distance, building materials, etc.
2. Prepare the CS for site survey
Refer to "3.9.4 Before Site Survey".
a.
Assign a CS number to each CS by setting the DIP switches on the back of the CS.
b.
Supply electricity to each CS using an AC adaptor/battery box or by connecting them to a CSIF/
DLC/DHLC card.
c.
Install each CS temporarily as planned.
Notes
• Install at least 2 m (6 ft 7 in) above the floor.
• Keep the antennas in the upright position.
3. Conduct the site survey
Refer to "3.9.5 Site Survey".
a.
Test the radio signal strength using the PS.
Confirm that the radio signal strength level is "12" near the CS.
Using the KX-TD7684/KX-TD7694
Using the KX-TD7680
Using the KX-TD7690
b.
By walking away from the CS with the PS, check the radio signal strength. The radio signal strength
weakens as you walk away from the CS.
c.
Map the CS coverage area at radio signal strength levels "3" and "8".
0
<< SEARCHING >>
CS NO.1 LEVEL:12
SAVE:0123456789
1 9
Press 1, 9, and POWER
for more than 2 seconds.
Display example:
1 to 9
CS No.
Display example:
Press 1, 9, and POWER
for more than 2 seconds.
<< SEARCHING >>
CS NO.1 LEVEL:12
SAVE:0123456789
1 to 9
CS No.
1 9
0
Display example:
Press 1, 9, and POWER
for more than 2 seconds.
<< SEARCHING >>
CS NO.1 LEVEL:12
SAVE:0123456789
1 to 9
CS No.
1 9 9