Panasonic KX-TDA5450, Installation Manual

Page: 76 / 86

4.1 Programming the PBX
Depending on the conditions in which the SIP-GW4 card is used, programming may be required for the PBX
using the Maintenance Console (PC programming software of the PBX):
Making Calls
With the default settings, the PBX sends calls to the SIP VoIP network 10 seconds after an extension user
completes dialing the telephone number.
Through programming the PBX, calls can be sent to the SIP VoIP network from the PBX as soon as dialing is
completed. The settings can be changed in the following two ways:
1) Pressing the # key
The PBX sends calls to the SIP VoIP network when the # key is pressed after dialing the telephone
number.
Programming Location of the Maintenance Console
2. System—9. System Options—Option 2—End of Dial Plan—[#] as End of Dial for en Bloc mode
Note
The programming above is same for ISDN.
2) Dialing Plan
The PBX sends calls to the SIP VoIP network when the dialed number is a preprogrammed telephone
number.
Programming Location of the Maintenance Console
•
3. Group—1. Trunk Group—1. TRG Settings—Main—Dialing Plan Table
•
3. Group—1. Trunk Group—4. Dialing Plan
Caller ID Configuration
To make the PBX send caller ID to the card when making calls (when " PBX Caller ID " is selected for Username
in "From" header or Username in "P-Preferred-Identity" header and "P-Asserted-Identity" header
in "3.4.1 Channel & SIP Telephony"), the following programming is required for the PBX.
Programming Location of the Maintenance Console
•
1. Configuration—1. Slot—Port Property
•
4. Extension—1. Wired Extension—ISDN CLIP
Caller ID Modification
When receiving calls via the SIP VoIP network, caller ID may not be displayed properly.
In that case, the caller ID can be edited through programming the PBX.
Programming Location of the Maintenance Console
•
3. Group—1. Trunk Group—1. TRG Settings—Main—Caller ID Modification Table
•
3. Group—1. Trunk Group—3. Caller ID Modification
For details about programming each setting, refer to the PC Programming Manual of the PBX.
76 Installation Manual Document Version 2008-10
4.1 Programming the PBX