2.3 Maintenance
Programming Guide
39
2.3
Maintenance
2.3.1
Status Control
1.
Click
2.1 Change RUN/STOP status
in the main menu.
Current RUN/STOP Status
shows the current status of the VoIP Gateway Card.
2.
Click
RUN
or
STOP
for
Status after changing
.
If you want to forcibly change the status from "RUN" to "STOP" while there are ongoing
calls, click the
Yes
check box for
Forced Disconnect when executing STOP
. This will
allow you to place the card in the "STOP" status even when there are ongoing calls.
At any time during the session, you can:
•
Click
MENU
to return to the main menu (see "2.1 Main Menu for the Administrator").
•
Click
LOGOUT
to log out from the IP-GW4 Maintenance Utility (see "2.5.2 Log Out").
3.
Click
OK
.
You will see a confirmation screen.
4.
Click
OK
.
You will see a result screen.
Note
If the operation is not successful, you will see an error screen. Click
OK
to return to
the previous screen, and then try again.
5.
Click
OK
.
You will be taken back to the
Change RUN/STOP status
screen.
