Panasonic KX-TDA15, Features Manual

Page: 380 / 420

2.3 System Data Control
380 Feature Guide
2.3 System Data Control
2.3.1 PC Programming
Description
This PBX can be programmed and administered using a PC. There are two programming methods:
1)
On-site Programming: System programming/diagnosis can be performed locally by connecting a
PC to the PBX directly.
2)
Remote Programming: System programming/diagnosis and data upload can be performed from
a remote location.
1.
On-site Programming:
2.
Remote Programming:
Method Description
Using the Serial Interface (RS-
232C) port The PBX has a Serial Interface (RS-232C) port which can be used
for either system administration or SMDR (
→
1.22.1 Station Message
Detail Recording (SMDR)).
Using the USB port The PC is connected to the USB port of the PBX, or a USB port (USB
Module) attached to a DPT.
Using the LAN interface An IP-GW4 card must be installed.
Using an ISDN TA interface
(64 kbps) through an ISDN
Extension Line Assign the floating extension number of the ISDN remote
maintenance (default: 699), and dial this number from the PC to
connect to the PBX.
This method is available only when a user-supplied ISDN TA that
supports CAPI is used.
Method Description
Using an external modem An external modem can be used to perform the remote programming.
An external modem can be connected to the Serial Interface (RS-
232C) of the PBX. Connect the modem to an extension port which is
assigned as the DIL/DID/DDI/MSN destination or to a trunk directly
to connect to the PBX from the PC. An AT command can be sent to
the modem automatically when it is connected to the Serial Interface
(RS-232C) port. AT commands can be programmed beforehand
through system programming to initialise the modem. An AT
command can also be sent manually in the PT system programming
mode.
Using an ISDN TA interface
(64 kbps) through an ISDN
Trunk The floating extension number of the ISDN remote maintenance must
be assigned (default: 699), and dial the DIL/DID/DDI/MSN number
whose destination is the floating extension number of the ISDN
remote maintenance.
This method is available only when an user-supplied ISDN TA that
supports CAPI is used.