Panasonic KX-TDA100 KX-TDA200, Installation Manual

Page: 36 / 194

2.1 Before Installation
36 Installation Manual
2.1 Before Installation
2.1.1 Before Installation
Please read the following notes concerning installation and connection before installing the Hybrid IP-PBX.
Be sure to comply with applicable local regulations (e.g., law, guidelines).
Safety Installation Instructions
When installing telephone wiring, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
1.
Never install telephone wiring during a lightning storm.
2.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected
at the network interface.
4.
Use caution when installing or modifying telephone lines.
5.
Anti-static precautions should be taken during installation.
Installation Precautions
This set is made for wall mounting (KX-TDA100/KX-TDA200) or floor standing (KX-TDA200 only). Avoid
installing in the following places. (Doing so may result in malfunction, noise, or discoloration.)
1.
In direct sunlight and hot, cold, or humid places.
Temperature range: 0 °C to 40 °C (32 °F to 104 °F)
2.
Sulphuric gases produced in areas where there are thermal springs, etc. may damage the equipment
or contacts.
3.
Places in which shocks or vibrations are frequent or strong.
4.
Dusty places, or places where water or oil may come into contact with the unit.
5.
Near high-frequency generating devices such as sewing machines or electric welders.
6.
On or near computers, telexes, or other office equipment, as well as microwave ovens or air
conditioners. (It is preferable not to install in the same room with the above equipment.)
7.
Closer than 1.8 m (6 ft) to radios and televisions (both the Hybrid IP-PBX and PTs).
8.
Do not obstruct the area around the Hybrid IP-PBX (for reasons of maintenance and inspection—be
especially careful to allow space of at least 20 cm (8 in) above and 10 cm (4 in) at the sides of the Hybrid
IP-PBX for cooling).
9.
Do not block the openings at top of the Hybrid IP-PBX.
10.
Do not stack up the optional service cards.
Wiring Precautions
Be sure to follow these instructions when wiring.
1.
Do not wire the telephone cable in parallel with an AC power source, computer, telex, etc. If the cables
are run near those wires, shield the cables with metal tubing or use shielded cables and ground the
shields.
2.
If cables are run on the floor, use protectors to prevent the wires from being stepped on. Avoid wiring
under carpets.