3.3 Data Management
Programming Guide
65
3.3.2
Handling of Firmware Page
1.
Click
2.2 Handling of Firmware Page
in the main menu.
For details about the parameters on this screen, refer to the descriptions below.
2.
Click
Main Operation Mode
for
Operation
to set the desired page as the active page on startup.
Note
Do not click
Empty
, as it is an option provided for engineer use only.
At any time during the session, you can:
•
Click
MENU
to return to the main menu (see "3.1 Main Menu for the Installer").
•
Click
LOGOUT
to log out from the IP-GW16 Maintenance Utility (see "3.4.2 Log Out").
3.
Click the option for the page in the "NEW" status for
Select Page
to specify it as the target page
of the operation.
4.
Click
OK
.
You will see a confirmation screen.
5.
Click
OK
.
You will see a result screen.
6.
Click
OK
.
You will be taken back to the
Handling of Firmware Page
screen.
Parameter Descriptions
Parameter & Description
Default
Value Range
IP-GW16 Program Version
Indicates the version of the VoIP Gateway Card's main
program in the firmware data of the corresponding page.
Display only
DSP Program Version
Indicates the version of the VoIP Gateway Card's DSP
program in the firmware data of the corresponding page.
Display only