Panasonic KX-TD1232NE, Programming Manual, Page: 90 / 352

2.2 System Programming
90 General Programming
[114] VM Command DTMF Set
Description
Sets the DTMF command signals transmitted to your Voice Processing System (VPS). There
are four commands available: Leave Message; Get Message; Automated Attendant Service;
Voice Mail Service. These commands are used in the following ways:
(A) If your VPS is used for Voice Mail (VM) Service
1.
Call Forwarding / Intercept Routing to Voice Mail
If a call is forwarded to the VPS, your system will send a mailbox number to the VM port.
This allows the caller to leave a message without knowing the mailbox number.
• Required entries (selections):
LV-MSG (Leave Message): This command is transmitted to a VM port if a call is
forwarded or intercepted and rerouted to the port.
AA-SVC (Automated Attendant Service): If AA Service is effective in programme
[990]
System Additional Information, Area 05 – bits 2 and 3, the "AA-SVC"
command is sent to a VM port if an incoming outside call is answered by the VM port.
• Other programming required (programme addresses): [106] Station Hunting Type;
[602] Extension Group Assignment; [609] Voice Mail Access Codes;
[990] System Additional Information, Area 05 – bits 2 and 3; [990] System
Additional Information, Area 02 – bit 8
2.
Hearing the message at the extension
If the VPS receives a message and lights the MESSAGE button indicator of the concerned
telephone, the telephone user can hear the message by pressing the MESSAGE button.
• Required entries (selections):
GETMSG (Get Message): This command is transmitted to a VM port when the message
receiver presses the MESSAGE button.
VM-SVC (Voice Mail Service): The "VM-Fkt" command is a code transmitted
preceding the "GETMSG." command above. This is effective to switch to VM port when
an AA port lights the MESSAGE indicator.
• Other programming required (programme addresses): [609] Voice Mail Access
Codes; [990] System Additional Information, Area 02 – bit 8.
(B) If your VPS is used for Automated Attendant (AA) Service
An AA port answers an incoming outside call to provide AA services, such as call transfer,
receiving a message.
• Required entries (selections):
VM-SVC (Voice Mail Service): The "VM-SVC" command is a code transmitted before
"LV-MSG" code if Operator transfers a call to an extension and then it is forwarded to
an AA port so that the AA port can be switched to VM port temporarily.
• Other programming required (program addresses): [106] Station Hunting Type,
[602] Extension Group Assignment.
Selection
• LV-MSG / GETMSG / AA-SVC / VM-SVC
• DTMF signal number: 16 digits (max.)