Panasonic KX-TA824, Feature Manual

Page: 13 / 178

1.1 General Features
Feature Manual 13
1.1.5 Automatic Configuration for Outside (CO) Line Type
Description
The dialing mode (DTMF [Dual Tone Multi-Frequency]/Pulse) of connected outside (CO) lines is
automatically assigned after restarting the PBX using the System Clear Switch or through system
programming (
[999] System Data Clear). No system programming in [401] Dial Mode and [402] Pulse
Speed is required unless the dialing mode of the connected outside (CO) line is Call Blocking. Automatic
Configuration for Outside (CO) Line Type can also be programmed the first time the PBX is accessed with
a PC using the KX-TA Maintenance Console software (Quick Setup). For more information about Quick
Setup, refer to the Installation Manual (
3.1.1 Installing KX-TA Maintenance Console on a PC).
Conditions
• If no outside (CO) lines are connected to the outside (CO) line ports of the PBX, the default values are
assigned automatically.
• It takes a maximum of 4 minutes to complete checking the dialing mode, unless the outside (CO) line
is in use. In this case, the PBX will start checking it after the outside (CO) line becomes idle.
• This feature will not function properly when:
– It takes 3 seconds or more to detect the dialing mode of your telephone company.
– The cable from the outside (CO) line is disconnected while the PBX is checking the dialing mode.
• If your telephone company or a host PBX can receive both DTMF and Pulse signals, the PBX selects
an outside (CO) line type according to the following priority:
DTMF Pulse (High) Pulse (Low)
Installation Manual References
3.1.1 Installing KX-TA Maintenance Console on a PC
4.1.5 System Reset with System Data Clear
Programming Manual References
[PT Programming]
[401] Dial Mode
[402] Pulse Speed
[999] System Data Clear
[PC Programming]
8.4 System Data Clear
9.3.3 Detail [3-3]—Dial Mode, Pulse Speed
Feature Manual References
1.1.39 Dial Type Selection