Panasonic KX-TA1232, Programming Manual

Page: 53 / 216

General Programming
Programming Guide 53
[109] Expansion Unit Type
Description
Assigns the type of expansion units to be used in the system.
This allows the system to identify the unit in each expansion unit location.
Selection
• Areas 1; 2; 3 = C / E1 / E2
(C: 4-Outside lines, E1: 8-Extension lines 1 /
E2: 8-Extension lines 2)
Default
C;E1;E2
Programming
1.
Enter 109.
Display: 109 EXPAND C, E1
2.
Press NEXT.
Display example: C ;E1;E2
3.
Keep pressing SELECT until the desired selection in Area 1 is displayed.
4.
Press to program another Area, if required.
5.
Keep pressing SELECT until the desired selection in the Area is displayed.
6.
Repeat steps 4 and 5 until all the required entries are completed.
7.
Press END.
Conditions
• The following units can be installed in the slots.
— C (4-Outside lines): 4 CO Line Expansion Unit
— E1, E2 (8-Extension lines):
8 Extension Expansion Unit
• There are three expansion areas in each system for the KX-TA1232, areas 1, 2 and 3 from
bottom to top. Up to two 8 Extension Expansion Units and one of 4 CO Line Expansion
Unit can be installed.
• After changing the setting, turn the Power Switch off and on once. Otherwise, the previous
setting will remain.
Features Guide References
Module Expansion
pg.book 53 ページ ２００１年７月３日 火曜日 午後２時４４分