Panasonic KX-T336, System Reference Manual

Page: 1535 / 1605

1.02 OUS (Out of Service) command
Description
At the operation prompt (OPE>), enter the OUS
command to change the status of the target
device (shelf, card, station etc.) to “Out of
Service” in on-line mode.
Command Format
OPE> OUS + Item No.
(Item)
Refer to Section 15-E-3.00 “TST command
(Test)” for details about the test command.
Conditions
The status of target devices (shelf, card, station)
should be “INS,” and the system must be in on-
line communication mode.
When you change the status of an upper device
(shelf, card), the status of lower devices (port,
station) change as follows.
Upper device INS OUS
Lower device INS OUS
Fault Fault
Normal operation
When this operation is executed without failure,
“OPE>” initial prompt appears again on the
screen.
Device
Shelf
Card
Port
Station
ATT
DTMF
CNF
Input Value
1 to 3 (physical number)
101 to 315 (physical number)
1011 to 3158 (physical number)
DNxxxx (xxxx: extension number;
three or four digits) or Physical
number: four digits
A1 or A2 or
Physical number: four digits
Rxxxy (xxx:Card number; y: 1 or 2)
CFBxx or CFOyy (xx: 01 to 08,
yy: 01 to 64)
Operation failed
An error message appears on the screen in the
following cases.
• Parameter error
• Not installed
• Status error
If the system administration terminal is an
Attendant Console (ATT), do not change the
status of the following devices from “INS” to
“OUS.”
• Shelf in which ATLC card is installed
• ATLC card
• Attendant console assigned as the
Maintenance Terminal
During remote operation, do not change the
status of the following devices from “INS” to
“OUS.”
• Shelf in which RMT card is installed
• RMT card (Modem)
15-C-2