22
Operating the built-in
answering device
Operating the answering device
from a remote location
Operation: Listening to a recorded message from a
remote location
Turn the
(Auto answer) light on before you go out. Remote
operations are available only from a touch tone telephone.
1. Call your unit.
2. Enter the remote operation ID during the greeting message.
3. Press
4
or wait 4 seconds.
Only the new recorded messages will be played back.
To listen to all the recorded messages, press
5
after
the new messages have been played back.
Night mode
Press
(Night mode) for about 3 seconds.
“
”
is displayed and
lights on.
When a call is received during night mode, the unit
will handle the call silently, either by storing the
received fax into memory or by recording the caller’s
message.
Night mode allows you to select a block of time
during which the unit will not ring for outside calls
or make sounds when you change the settings.
This feature is useful when you do not want to be
disturbed, for example, while sleeping.
Turn off the night mode
Press
(Night mode) for about 3 seconds.
Printing received fax documents
When new faxes are received,
(Caller ID log/Fax
print indicator) will light on.
To print the faxes, see “Printing a specific fax stored in
memory” on page 19.
Turn on the night mode
light on
Preparation: Setting the remote operation ID
1. Press
機能/
決定
(Function/Set).
2. Press
.
3. Press
機能/
決定
(Function/Set).
4. Enter any 4-digit number (remote operation ID) except
or #.
5. Press
機能/
決定
(Function/Set).
6. Press
(Stop).
Example:
留守電暗証番号
1234
Listening to recorded messages
When new messages are recorded, the following will be
displayed.
To listen to the messages, see “Listening to the newly
recorded messages” on page 21.
新しい用件が
録音されました
Setting the unit to automatically answer incoming calls to
enable you to check the caller’s voice when you are at home
You can set the unit so that when you receive an
incoming call, you can check the caller’s voice emitted
from the speakerphone of the main unit.
This function operates when
is unlit.
You can answer the telephone after checking the
caller’s voice.
When you do not wish to answer the telephone, either
press
or wait for about 30 seconds, and the
connection will be broken.
When using number display, the above function will
not operate if you receive a call from a party who is
registered in the phonebook inside the main unit.
1
Press
機能/
決定
(Function/Set).
2
Press
, and then press
機能/
決定
(Function/Set).
3
Press
(Search button) to select “
あり
”,
then press
機能/
決定
(Function/Set).
4
Press
to select the number of rings,
and then press
機能/
決定
(Function/Set).
5
Press
(Stop).