Tearing off Paper
With fanfold paper installed, this function allows you to
advance your paper to the tear position. After tearing off
the page you can return your paper to the first printer
line by pressing
TEAR OFF
again.
If
TEAR OFF
is not pressed a second time, the
printer will automatically reverse to the first print line
upon receiving data from the computer.
1.
Press
TEAR OFF
to advance the paper to
the tear position.
2.
Tear off the page.
3.
Press
TEAR OFF
to reverse the paper back
to the first print line.
Self Test
The printer has a self test feature which allows you to
test the printer. When activated, this feature will print 5
lines of each resident font. When complete, it will return
to the draft font and continue for approximately 20
minutes.
1.
Install the ribbon cassette and paper, then turn
the power off (Page 18–24).
2.
While pressing
LF/FF
turn the power on, then
release.
A sample printout will begin, which serves as a self
test.
3.
Once you see that the printer is functioning
properly, you may turn the power off during the
self test, or you may run the entire test.
24
Operating Instructions
Setup
