Light Pattern
PDN Button Status
SDN Button Status
Flashing red
slowly
A corresponding SDN extension is holding
a call.
Another corresponding SDN
extension, or the PDN extension itself,
is holding a call.
Flashing red
rapidly
The PDN extension is receiving an
incoming call to an incoming call
distribution (ICD) group.
The corresponding PDN extension is
receiving an incoming call.
SDN Direct Dial
Using an SDN button, you can easily call the corresponding PDN extension. SDN buttons are in one of two
modes depending on system programming, and the operation procedure differs as follows:
Enhanced DSS Key Mode
PT/PS
Off-hook.
Talk.
Press corresponding
SDN
.
(SDN)
Standard SDN Key Mode
Off-hook.
Talk.
Press corresponding
SDN
.
(SDN)
D.Tone
Press the
SDN
again.
PT/PS
(SDN)
•
When performing SDN Direct Dial to call the corresponding PDN extension, the SDN button
light shows the current status of the destination extension as follows:
Green on
: You are using the line.
Red on
: The line is being used. (The PDN extension, or another SDN extension when
multiple extensions have SDN buttons to a same PDN extension, is using the line.)
•
Even if a PDN extension has set Do Not Disturb (DND), you can call the extension as
normal by pressing the SDN button.
•
When an SDN button is in Standard SDN Key Mode, you can dial a telephone number while
hearing a dial tone, instead of pressing the SDN button again. Depending on system
programming, your call will be made using either your normal calling privileges (Class of
Service) or those of the corresponding PDN extension (
SDN Walking COS
).
Call Hold and Call Hold Retrieve
You can put calls answered with a PDN or SDN button on hold normally (→
1.5.1 Primary Directory Number (PDN)/Secondary Directory Number (SDN) Extension
Operating Manual
83
Summary of Contents for KX-NSX2000
