Panasonic KX-NS300CN, Pc Programming Manual

Page: 287 / 884

9.20 PBX Configuration—[1-1]
Configuration—Slot—V-UTEXT—Port Property
Various settings can be programmed for the ports of V-UTEXT8 cards.
KX-UT Series SIP Phone Registration and De-registration
A KX-UT series SIP phone must be registered to the PBX by programming the PBX and SIP phone before it
can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the SIP phone later.
Registration, De-registration, and Forced De-registration can be performed only in On-line mode.
Note
KX-UT series SIP phones are not available in China.
Preparation
Open 27.1 Network Service—[1] IP Address/Ports—Basic Settings , and confirm that the IP addresses of
the mother board and DSP card, subnet mask address, and default gateway address are set.
Registration
Follow the steps below to register a SIP phone.
1.
Connect the device to be registered to the network and, if necessary, the power supply.
2.
Click Registration .
A dialogue box will appear. Non-registered (available) extension numbers and names are displayed on the
left.
3.
Highlight numbers and names and click the right arrow to select them for registration. Click Next .
4.
Click Next .
5.
If the registration is still in progress, the dialogue box will show "Registration Executing".
If the registration is successful, the dialogue box will show "Registration Completed". Click
Close .
Once the device is successfully registered, the status of the device will update to show "Registered".
De-registration
Follow the steps below to de-register a SIP phone.
1.
Click De-registration .
A dialogue box will appear. Registered extension numbers and names are displayed on the left.
2.
Highlight numbers and names and click the right arrow to select them for de-registration. Click Next .
A dialogue box will appear.
3.
Click Confirm .
If the de-registration is successful, the dialogue box will show "De-registration Succeed".
4.
Click Close .
Once the device is successfully de-registered, the status of the device will update to show "None".
Forced De-registration
Follow the steps below to forcibly de-register a SIP phone when normal de-registration has been unsuccessful
or IP address settings have been changed or deleted only on the target device.
PC Programming Manual 287
9.20 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT—Port Property